Netgear UTM25-100NAS ユーザーズマニュアル

Network and System Management

10-17

2. Select Save file, and then click OK.

3. Open the folder where you have saved the backup file, and then verify that it has been saved 

successfully.

Note the following:

•

If your browser is not configured to save downloaded files automatically, locate the folder in 
which you want to save the file, specify the file name, and save the file.

•

If you have your browser configured to save downloaded files automatically, the file is saved 
to your browser’s download location on the hard disk.

To restore settings from a backup file: 

1. On the Backup & Restore Settings screen (see 

), next to Restore 

save settings from file, click Browse.

2. Locate and select the previously saved backup file (by default, backup.pkg). 

3. When you have located the file, click the restore button. A warning screen might appear, and 

you might have to confirm that you want to restore the configuration.

The UTM reboots. During the reboot process, the Backup & Restore Settings screen remains 
visible. The reboot process is complete after several minutes when the Test LED on the front panel 
goes off.

Warning: Restore only settings that were backed up from the same software version. 

Restoring settings from a different software version can corrupt your backup 
file or the UTM system software.

Warning: Once you start restoring settings, do not interrupt the process. Do not try 

to go online, turn off the UTM, shut down the computer, or do anything 
else to the UTM until the settings have been fully restored.