Sharp MX-M182D ユーザーズマニュアル

When feeding large 
paper such as B4 and A3 
(8-1/2" x 14" and 
11" x 17"), pull out the 
bypass tray extension.

To prevent a misfeed, 
verify once more that the 
paper guides are 
adjusted to the width of 
the paper.

• Up to 100 sheets of standard copy paper can be set in the bypass tray.
• Be sure to place A6, B6 or 5-1/2" x 8-1/2" size paper or envelopes horizontally as shown in the following diagram. 

(When using the printer: Same as the direction for the A4 size paper, etc)

• When loading envelopes, make sure that they are straight and flat and do not have loosely glued construction flaps 

(not the closure flap).

• Special papers except SHARP recommended transparency film, labels, and envelopes must be fed one sheet at a 

time through the bypass tray.

• When adding paper, first remove any paper remaining in the tray, combine it with the paper to be added and then 

reload as a single stack. The paper to be added must be the same size and type as the paper already in the tray.

• Do not use paper that is smaller than the original. This may cause smudges or unclean images.
• Do not use paper that has already been printed on by a laser printer or plain paper fax machine. This may cause 

smudges or unclean images. 

• If you loaded paper in the bypass tray, 

press the [PAPER SELECT] key to select 
the bypass tray.

• If you load thick paper in the bypass tray, 

press the [PAPER] key until "EXTRA" is 
highlighted. The paper type is set to thick 
paper. The setting is cleared when "Auto 
clear" works or the [CA] key is pressed. 
For restrictions on paper types and 
weights, see "PAPER" 

.

Available

Not 

available