Sharp MX-M182 ユーザーズマニュアル
34
COPY FUNCTIONS
3
SELECTING THE TRAY
Auto paper select mode
normally operates (unless it has been disabled), and thus when the original is placed
on the document glass and the original size is selected, or when the original is placed in the SPF/RSPF, the tray with
the same size of paper as the original is automatically selected. If you wish to use a tray other than the automatically
selected tray (for example you wish to enlarge or reduce the copy or use the bypass tray), press the [PAPER
SELECT] key to select the desired tray.
the same size of paper as the original is automatically selected. If you wish to use a tray other than the automatically
selected tray (for example you wish to enlarge or reduce the copy or use the bypass tray), press the [PAPER
SELECT] key to select the desired tray.
Auto tray switching (when there are two or more paper trays)
If the tray runs out of paper during copying and there is another tray with the same size of paper and the same
feeding orientation (horizontal or vertical), the other tray is automatically selected and copying continues. "Auto tray
switching" can be disabled in the system settings
feeding orientation (horizontal or vertical), the other tray is automatically selected and copying continues. "Auto tray
switching" can be disabled in the system settings
SETTING THE NUMBER OF COPIES
Press the numeric keys to set the number of copies.
• The set number of copies appears in the display. A maximum of 999 copies (factory default setting) can be set.
• A single copy can be made even if "0" is displayed.
• A single copy can be made even if "0" is displayed.
Important note when making a large number of copies
If the number of sheets output to the centre tray exceed its maximum capacity (250 sheets when a job separator tray
kit is not installed, 150 sheets when a job separator tray kit is installed) during a copy job, the copy job will stop
temporarily. If this happens, promptly remove the copies and press the [OK] key to resume copying. The copy job
will step each time the number of sheets in the centre tray reach its maximum capacity.
Before starting a long copy run, remove any sheets that remain in the centre tray. During output of the copy job,
exercise care as the job may stop frequently due to the centre tray becoming full.
kit is not installed, 150 sheets when a job separator tray kit is installed) during a copy job, the copy job will stop
temporarily. If this happens, promptly remove the copies and press the [OK] key to resume copying. The copy job
will step each time the number of sheets in the centre tray reach its maximum capacity.
Before starting a long copy run, remove any sheets that remain in the centre tray. During output of the copy job,
exercise care as the job may stop frequently due to the centre tray becoming full.
• If the desired paper size does not appear, change the paper in a tray to the desired paper size.
• Automatic ratio selection
selected.
• If you enter the wrong number, press the [C] key and enter the correct number.
• The limit for the number of copies can be changed in the system settings.
• The limit for the number of copies can be changed in the system settings.
COPY RATIO
ADDRESS
ADDRESS
ADDRESS
EXPOSURE
COLOUR MODE
PROGRAM
PROGRAM
PAPER SELECT
RESOLUTION
RESOLUTION
RESOLUTION
RESOLUTION
AUT
FO
BRO
Note
WXYZ
Note