Sharp AL-1633 ユーザーズマニュアル
13
1
SET-UP
1
Remove all pieces of tape, then open
the SPF or the document cover and
remove the protective material.
the SPF or the document cover and
remove the protective material.
2
Use a coin (or other suitable object) to
remove the screw.
remove the screw.
3
Install the TD cartridge.
For installation of the TD cartridge, see the next
page.
page.
4
Gently lift and pull out the paper tray
until it stops.
until it stops.
5
Remove the pressure plate lock.
Rotate the pressure plate lock in the
direction of the arrow to remove it
while pressing down the pressure
plate of the paper tray.
Rotate the pressure plate lock in the
direction of the arrow to remove it
while pressing down the pressure
plate of the paper tray.
6
Store the pressure plate lock which
has been removed in step 5 and the
screw which has been removed in
step 2 in the front of the paper tray.
has been removed in step 5 and the
screw which has been removed in
step 2 in the front of the paper tray.
To store the pressure
plate lock, rotate the lock
to fix it on the relevant
location.
For two-tray model,
follow steps 4 to 6 for
both the upper and lower
trays except for storage
of the screw.
plate lock, rotate the lock
to fix it on the relevant
location.
For two-tray model,
follow steps 4 to 6 for
both the upper and lower
trays except for storage
of the screw.
7
Ensure that the power switch of the
machine is in the OFF position. Plug
the power cord into the nearest outlet.
machine is in the OFF position. Plug
the power cord into the nearest outlet.
Store the screw in the paper tray as described
in step 6 because it must be used if the
machine has to be moved. (p.69)
in step 6 because it must be used if the
machine has to be moved. (p.69)
Note
• If you use the machine in a country other
than the country where the machine was
purchased, you will need to make sure that
your local power supply is compatible with
your model. If you plug the machine into an
incompatible power supply, severe damage
to the machine will result.
purchased, you will need to make sure that
your local power supply is compatible with
your model. If you plug the machine into an
incompatible power supply, severe damage
to the machine will result.
• Only insert the power cord into a properly
grounded wall socket. Do not use extension
cords or power strips.
cords or power strips.
Connect the machine to a power outlet which
is not used for other electric appliances. If a
lighting fixture is connected to the same
outlet, the light may flicker.
is not used for other electric appliances. If a
lighting fixture is connected to the same
outlet, the light may flicker.
Pressure
plate lock
plate lock
Screw
Caution
Note
AL-1633_1644_EX.book 13 ページ ２００３年１０月２３日 木曜日 午後８時２１分