Sharp UX-B800SE ユーザーズマニュアル

2. F

a

x to 

E-mail

The machine requires an IP address to 
communicate on the Internet.

If your network is set up to 
automatically assign IP addresses, you 
do not need to do anything; the 
machine will automatically receive an 
IP address when it is connected.

Automatic assignment of IP addresses 
is normally performed by a DHCP 
server, which may be a computer, 
router, or other device on the network. 
(Most routers used on home networks 
contain a DHCP server.)

If your network requires that a static 
(permanent) IP address be assigned to 
the machine, see Network Settings on 
page 23 to enter the IP address and 
related information. 

To check the machine’s IP address and 
verify that the machine is able to 
communicate on the network, follow 
these steps.

Press , 

then  

until 

[NETWORK SETTING] appears

.

Press , 

then  

to 

show

 

[NETWORK INFORMATION]

Press .

•

If the machine has automatically 
received an IP address and is able 
to communicate, [IP ADDRESS/
DHCP: ON] will appear on the top 
line of the display, followed by the IP 
address on the bottom line. To show 
the machine’s host name, press 

.

•

If a static IP address has been 
entered in the machine and the 
machine is able to communicate, 
[IP ADDRESS/DHCP: OFF] will 
appear on the top line of the display, 
followed by the IP address on the 
bottom line. To show the machine’s 

host name, press 

.

•

If the machine was unable to 
receive an IP address automatically, 
or if the router locked up after the 
machine received an IP address,
[IP ADDRESS/DHCP: FAIL] / 
[192.168. 1 .201] will appear. 
“192.168. 1 .201“ is an IP address 
that is assigned to the machine for 
diagnostic purposes when 
connection fails (it cannot be used 
for regular communication).

•

If a cable has not been connected, 
[CHECK CABLE] will appear.

•

If [NOW CONNECTING / CHECK 

LATER] appears, press 

 to exit, 

wait briefly, and then repeat the 
procedure again.