Sharp UX-B800SE ユーザーズマニュアル
Sending a Fax: Auto Dialing
30
Sending a fax by Direct Keypad
Dialing
Dialing
Use this method to dial a full fax
number without using the handset .
number without using the handset .
1
Load the document(s).
•
If desired, press
to set the
resolution and/or contrast.
2
Enter the number of the receiving
machine with the number keys.
machine with the number keys.
•
If a pause is required between any of
the digits to access a special service
the digits to access a special service
or an outside line, press
. The
pause will appear as a hyphen (two
seconds per pause). Several pauses
can be entered in a row.
seconds per pause). Several pauses
can be entered in a row.
3
Check the display. If the number
shown is correct, press
.
•
If the number is not correct, press
to clear the incorrect digits, and
then re-enter the correct digit(s).
Redial
You can automatically redial the last
number dialed on the machine.
number dialed on the machine.
1
Load the document(s).
•
If desired, press
to set the
resolution and/or contrast.
RESOLUTION/
RECEPTION MODE
FUNCTION
STOP
RESOLUTION/
RECEPTION MODE
2
Press
once. Make sure the
display shows the number you wish
to dial.
to dial.
3
If you are sending a fax, press
. Dialing begins.
If you are making a phone call, lift
the handset. Dialing begins.
the handset. Dialing begins.
Note: If the transmission is
unsuccessful and [DOCUMENT
JAMMED] appears in the display,
remove the document as explained on
page 62.
unsuccessful and [DOCUMENT
JAMMED] appears in the display,
remove the document as explained on
page 62.
Automatic redialing
If you use auto dialing (including Direct
Keypad Dialing) to send a fax and the
line is busy, the machine will
automatically make three redial
attempts at intervals of five minutes.
Keypad Dialing) to send a fax and the
line is busy, the machine will
automatically make three redial
attempts at intervals of five minutes.
During this time, [RECALLING] will
appear in the display, followed by the
attempt number. You will not be able to
dial any other locations while the
message appears.
appear in the display, followed by the
attempt number. You will not be able to
dial any other locations while the
message appears.
♦
To clear the message and stop
automatic redialing, press
.
Under certain conditions, automatic
redialing may stop before three
redialing attempts are made.
redialing may stop before three
redialing attempts are made.
STOP