Sharp UX-B800SE ユーザーズマニュアル

To select AUTO mode, press 

 (with no document in the 

feeder) until [AUTO] appears in the 
display.

In AUTO  mode, the machine 
automatically answers all calls on 4 
rings and receives incoming faxes.

♦

If you pick up the handset before the 
machine answers, you can talk to the 
other party and receive a fax as 
explained in Using MANUAL Mode 
below.

To change the number of rings on 
which the machine answers calls, 
change the “NUMBER OF RINGS” 
setting (p. 45).

Important: If a document is loaded in 
the machine’s feeder, remove it before 
performing the steps below.

When the machine rings, pick up 
the handset.

If you hear a fax tone, wait until the 
display shows [RECEIVING] and 
then replace the handset.

•

If [RECEIVING] does not appear (or 
if you have set the Fax Signal 
Receive setting to NO (pp. 45, 47)), 

press 

 to begin reception.

If the other party first speaks with 
you and then wants to send a fax, 

press 

 after speaking. (Press 

before the sender presses their 
Start key.)

•

When [RECEIVING] appears in the 
display, hang up.

The machine automatically reduces 
received faxes as needed to fit the 
paper. If you prefer to have all faxes 
printed at full size, change the 
“RECEIVE RATIO” setting (pp. 45 
and 48).

To select MANUAL mode, press 

 (with no document in the 

feeder) until [MANUAL] appears in 
the display.

In MANUAL mode, you must answer all 
calls (even faxes) by picking up the 
machine’s handset or an extension 
phone connected to the same line.

Answer the extension phone when 
it rings.

 

If you hear a soft fax tone, wait until 
you hear pronounced, high-pitched 
fax tones, then hang up.

 

If the machine doesn't respond, or if 
the other party first talks to you and 
then wants to send a fax, set the 
phone down (do not hang up), walk 
over to the machine, lift the