Sharp UX-B800SE ユーザーズマニュアル

The Anti Junk Fax function blocks 
reception of faxes from a fax number 
that you specify.

To use this function, enter the fax 
number that you want to block. Only one 
number can be entered.

Press 

, then 

 until 

[

ENTRY MODE] appears

.

Press , 

then  

until 

[

JUNK #] appears.

Press 

 (SET) to store an Anti 

Junk number. 
(To clear a previously stored 

number, press 

 (CLEAR) and 

go to Step 5.)

Enter the number with the number 
keys (max. 20 digits).

Press .

Press  

to 

exit.

♦

When a fax is blocked (or when a 
voice call is blocked if you are using 
the Caller ID function), a transaction 
report (page 51) will print to inform 
you (unless “TRANSACTION LIST” on 
page 46 is set to “NEVER PRINT”).

Duplex Scanning is convenient for 
transmitting or copying two-sided 
documents. When this function is 
selected, you simply feed all pages of 
the document through the machine 
once, turn the stack of pages over, and 
feed the stack through again. The 
machine will automatically sort the 
pages into the correct order (front of 1st 
page, back of 1st page, front of 2nd 
page, back of 2nd page, etc.). 

♦

Note that any blank sides must be 
included when scanning the pages (if 
the number of pages is not equal 
each time the machine scans the 
stack, an error will result).

Load the documents. Make sure the 
pages are placed front-side down, 
with the first page on the bottom.

•

If desired, press 

 to set the 

resolution and/or contrast.

Press  

and 

then .

Perform all steps of the desired copy 
or transmission operation.

When all pages of the document 
have been scanned, turn the stack 
over (do not change the page order) 
and load the stack again.

Press .

DUPLEX