Sharp UX-B800SE ユーザーズマニュアル

ページ / 76
Messages and Signals
59
10.
 T
roub
le-
shooting
Display messages
Note: If you have turned on the Caller ID function, see page 38 for display 
messages related to Caller ID.
ADD PAPER & /
PRESS START KEY
(alternating messages)
Check the printing paper. If the tray is empty, add paper 
and then press 
. If there is paper in the tray, make 
sure it is inserted correctly (take out the stack, align the 
edges evenly, and then reinsert it in the tray) and then 
press .
CHANGE CARTRIDGE
This message appears after you install or replace the 
print cartridge (see page 10).
CHECK CARTRIDGE
The print cartridge is missing and must be installed, or 
is not installed correctly.
CONNECTION ERROR
A Fax to E-mail transmission was not successful 
because of a communication problem on your local 
network. This is usually due to a problem with the cable 
connections. Make sure that the cable ends are 
securely inserted in the LAN ports. Make sure that the 
correct cable is being used and that the cable is good. 
Make sure that your router or hub is powered on.
CHECK E-MAIL SETTING Fax to E-mail transmission is not possible because the 
SMTP server or the sender address has not been 
specified in the e-mail settings (see page 17).
DOCUMENT JAMMED
The original document is jammed. See the following 
section, Clearing Paper Jams. Document jams will occur 
if you load more than 20 pages at once or load 
documents that are too thick (see page 24). The 
document may also jam if the receiving machine doesn’t 
respond properly when you attempt to send a fax.
FAX RX IN MEMORY
A fax has been received in memory because the print 
cartridge needs replacement, you have run out of 
printing paper, or the paper is jammed. The fax will print 
out automatically when the problem is fixed.
Messages and Signals