Pitney Bowes DA700 ユーザーズマニュアル

Reason: 

Feed Ramp not used.

Solution:  The feed ramp adds a gentle slope to the  

 stack and helps feeding. If you’re using the 

prop, check the H-Block gap for proper separa-

tion. Also make sure the wire frame is centered 

under the material. See Chapter 3.

Reason: 

Dirty feed rollers.

Solution:  Clean the feed roller with the Pitney Bowes Mul-

tipurpose Cleaning Kit (Number 902-0).  

DO NOT  use any other solvents or detergents. 

They could damage the feed rollers.

Reason: 

Paper dust present (yellow or white residue),    

 blocking feed sensor. 

Solution:  Clean sensor with compressed air (see page 

5-3).

Reason: 

Too much material in feeder (too heavy). Weight  

 of stack must be 20 lbs. or less.  

Solution:  Remove some material from stack. 

Before calling our Technical Operations Center or your Pit-

ney Bowes Customer Service Representative, look for your 

problem below. If you can solve the problem yourself, you 

will be able to resume printing sooner. Also review the FAQs 

on our web site.