Sharp JW-20FLT ユーザーズマニュアル

5-1

                              

Chapter 5: Installation

This section describes the installation procedures for the JW-20FL5/20FLT (hereafter referred to as the
module) on the JW20H/30H basic rack panel.

 Turn off the power to the JW20H/30H.

 Set the module No. switch on the back of the module.

 Insert the mounting rib on the module into the rib insert holes on the JW20H/30H basic rack panel

and push in. Then, tighten module-mounting screws at the top of the module using a Phillips-head
(+) screwdriver.

Notes

- The module cannot be installed into an expansion rack panel.
- More than two communication modules can be installed on the same control module (basic rack panel

for the JW20H/30H). However, be careful not to use the same module No. switch setting for any other
module (including JW-20FL5/20FLT).

- Make sure to tighten the module mounting screws securely. Loose screws may cause a malfunction.

(Back of the communication module)

Module No. switch

Module rib 

insert hole
Module rib

Intermediate plate 

or control panel

Basic rack panel

Module insert guide

This module

Ventilation hole

Module mounting screw

Basic rack panel

  The module
   (The figure shows a JW-20FL5.)

Control module

 

JW-21CU/22CU, JW-31CUH1/32CUH1

 

JW-33CUH1/33CUH2/33CUH3

＋ 

Phillips-head 

      screwdriver

Power supply module