Canon 5075 ユーザーズマニュアル
Placing Originals
2-40
2
Basic Oper
ations
2
Neatly place your originals with the side to be copied face up
into the original supply tray.
into the original supply tray.
Place your originals as far into the feeder as they will go, until the Original Set
indicator is lit.
indicator is lit.
If any dirt on the original scanning area is detected when the originals are placed
in the feeder, a screen prompting you to clean the original scanning area
appears. Even though streaks may appear on the copies, you can continue to
scan your documents by pressing [Done].
in the feeder, a screen prompting you to clean the original scanning area
appears. Even though streaks may appear on the copies, you can continue to
scan your documents by pressing [Done].
It is recommended, however, that you open the feeder, clean the scanning area,
and then close the feeder. The following screen will not appear once the
scanning area is clean.
and then close the feeder. The following screen will not appear once the
scanning area is clean.
For instructions on cleaning the original scanning area, see Chapter 7, "Routine
Maintenance."
Maintenance."
If the original scanning area in the feeder is dirty, press [Display Procedure] on
the screen to check the cleaning procedure, then clean the original scanning
area. (See "Cleaning the Original Scanning Area," on p. 7-60.)
the screen to check the cleaning procedure, then clean the original scanning
area. (See "Cleaning the Original Scanning Area," on p. 7-60.)
Original Set Indicator