Samsung SC-140 ユーザーズマニュアル

4

5

Turn OFF your computer. Remember to verify the
configuration jumper on the rear of the CD-ROM drive.

Remove the cover of your PC. (main unit of the computer)

Remove the blank cover panel of the 5.25 inch unit in
which the CD-ROM drive is to be installed.

Put the cover back on your PC.

Install the CD-ROM drive into the unit and secure it with
mounting screws. (recommended standard M3x6x4)
☛ ◆ Depending on your PC model, you may need to 

attach guide rails to the drive, so that the drive is 
held firmly in place.

☛

◆ If you use screws that are longer than the 

recommended standard, you may damage the 
drive.

Before you install the CD-ROM drive, we strongly recommend that you make certain
that your set-up meets the system requirements listed below.

Install the CD-ROM drive in your computer horizontally, making sure that the Open/Close
button is on the right.

Connect the CD-ROM drive to the IDE interface and power
cables Iocated inside your computer. 
☛ Connectors are keyed so it is impossible to put them in 

an incorrect position. Do not force the connectors, if they 
do not seem to fit.

Windows version

MS-DOS version

Disk space

Free expansion unit

Type of computer

3.1(or higher)

5.0(or higher)

100KB minimum

5.25 inch

IBM 486SX 20MHz (or higher) with 
an IDE interface(or a 100% IBM-
compatible computer)

You can install the device driver for DOS or for Windows.

¡

Do not install DOS Driver when the program of Windows 95/98 is going on.
(Remark CD-ROM Driver in the state of CONFIG. SYS.)

Turn on your computer and wait for it to boot.

Insert the driver disk into a floppy disk drive(usually the A drive).

If you are a...
DOS user

Windows user 

Windows 95/98 user

◆ Type a: at the DOS prompt
◆ Press the RETURN key

◆ Access the File Manager
◆ Click on the A icon.

◆ 

Type CDSETUP after the 

prompt 

◆ 

Press RETURN

Double-click CDSETUP.EXE from the Windows
File Manager

◆ When you are in Windows 95/98, it is not 

◆ 

necessary to install Device Driver. 

◆ 

Whereas, when you are in Dos Mode of 

◆ 

Windows 95/98, then install as follows. 

◆ Click on MY COMPUTER icon.   
◆ Click on the A icon.

Run the CDSETUP program:

Confirm the installation

Y

Exit without installing

N

When the Setup Completed screen is displayed, remove the installation
floppy disk from the drive.

Reboot your system.

If you answer Y(Yes), the installation program automatically
◆ Creates a SAMSUNG directory on your hard disk 
◆ Copies the required softwares (mscdex.exe and sscdrom.sys)
◆ Modifies the CONFIG.SYS and AUTOEXEC.BAT files

Result : 

◆ The computer restarts
◆ Both the device driver and MSCDEX are loaded

Result : 

DOS user

Windows user