Seagate ST1200MM0017 ユーザーズマニュアル

S

EAGATE 

E

NTERPRISE 

P

ERFORMANCE 

10K HDD 

V

7  P

RODUCT 

M

ANUAL

, R

EV

. C

  25

  

a. Operating—normal

The drive as installed for normal operation, shall comply with the complete specified performance while subjected to con-
tinuous vibration not exceeding
5-500 Hz @ 0.5 G (zero to peak)
Vibration may be applied in the X, Y, or Z axis.
Operating normal translational random flat profile
10 - 500 Hz (translational random flat profile)

0.5 GRMS

b. Non-operating

The limits of non-operating vibration shall apply to all conditions of handling and transportation. This includes both iso-
lated drives and integrated drives.
The drive shall not incur physical damage or degraded performance as a result of continuous vibration not exceeding 

5-500 Hz @ 3.0 G (zero to peak)

Vibration may be applied in the X, Y, or Z axis.
Non-operating translational random flat profile
10 - 500 Hz  (translational random flat profile)

2.4 GRMS

The drive is designed to operate in a typical office environment with minimal environmental control.

Seagate electronic drive components pass accelerated corrosion testing equivalent to 10 years exposure to light industrial 
environments containing sulfurous gases, chlorine and nitric oxide, classes G and H per ASTM B845. However, this 
accelerated testing cannot duplicate every potential application environment.

Users should use caution exposing any electronic components to uncontrolled chemical pollutants and corrosive chemicals 
as electronic drive component reliability can be affected by the installation

 

environment. The silver, copper, nickel and gold 

films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur 
is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the 
surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%. Materials 
used in cabinet fabrication, such as vulcanized rubber, that can outgas corrosive compounds should be minimized or 
eliminated. The useful life of any electronic equipment may be extended by replacing materials near circuitry with sulfide-free 
alternatives.

Sound power during idle mode shall be 3.1 bels typical when measured to ISO 7779 specification.

There will not be any discrete tones more than 9 dB above the masking noise on typical drives when measured according to 
Seagate specification 30553-001. There will not be any tones more than 24 dB above the masking noise on any drive.