Seagate ST9550AG ユーザーズマニュアル
•
The FDISK program on your DOS utilities diskette may be
corrupted. Try running the program from a different diskette.
corrupted. Try running the program from a different diskette.
•
If you are using a version of DOS prior to Version 4.0, make
the drive partitions smaller than 32 Mbytes.
the drive partitions smaller than 32 Mbytes.
•
Try another drive type or translation geometry. Sometimes the
host BIOS does not accept a particular translation geometry even
though that geometry is listed as an option during system setup.
host BIOS does not accept a particular translation geometry even
though that geometry is listed as an option during system setup.
•
Make sure that the host adapter is not assigned an interrupt
that is already in use by another device. Modify the interrupt
jumpers if necessary.
that is already in use by another device. Modify the interrupt
jumpers if necessary.
During the FDISK program, the error message, “No Fixed
Disk Present,” appears.
Disk Present,” appears.
•
Check all cables.
•
Check the power supply.
•
Reboot the computer and make sure the drive spins up.
•
Verify the BIOS drive type.
•
Check for I/O address conflicts.
During high-level formatting, the drive keeps finding hard
errors and reporting the following message. “Attempting to
recover allocation units. . .”
errors and reporting the following message. “Attempting to
recover allocation units. . .”
•
This is normal with DOS Version 4.0 or later. The drive will format
normally. However, after formatting the drive, you may want to
run a third-party surface-scan program to check for bad sectors.
normally. However, after formatting the drive, you may want to
run a third-party surface-scan program to check for bad sectors.
During high-level formatting, the drive does not format to
full usable capacity.
full usable capacity.
•
Verify the BIOS drive type. Your drive’s formatted capacity is
limited to the capacity of the BIOS geometry you selected. If
your BIOS does not offer a geometry that takes advantage of
limited to the capacity of the BIOS geometry you selected. If
your BIOS does not offer a geometry that takes advantage of
ST9655 Family Installation Guide, Rev. A
15