Seagate ST32430N/ND ユーザーズマニュアル
26 Hawk 2LP Family Installation Guide, Rev. B
_____________________________________________________________________________________________________________
J2 Jumper
Position
Position
Jumper Function Description
TE
(Applies to "N" models only)
On
With the jumper installed, the On-board (non-
removable) terminator circuits are enabled (con-
nected to the I/O lines). Default is jumper in-
stalled.
removable) terminator circuits are enabled (con-
nected to the I/O lines). Default is jumper in-
stalled.
Off
Terminator circuits are disabled.
DS ME
Off Off
Off Off
Spindle starts immediately after power up - De-
fault setting.
fault setting.
Off On
Drive spindle does not start until Start Unit com-
mand received from host.
mand received from host.
On Off
Spindle Startup is delayed by SCSI ID times 12
seconds after power is applied, i.e., drive 0
spindle starts immediately when DC power con-
nected, drive 1 starts after 12 second delay, drive
2 starts after 24 second delay, etc.
seconds after power is applied, i.e., drive 0
spindle starts immediately when DC power con-
nected, drive 1 starts after 12 second delay, drive
2 starts after 24 second delay, etc.
On On
Drive spindle starts when Start Unit command
received from host. Delayed start feature is over-
ridden and does not apply when ME jumper is
installed.
received from host. Delayed start feature is over-
ridden and does not apply when ME jumper is
installed.
WP
On
On
Entire drive is write protected.
Off
Drive is not write protected. Default is no WP
jumper installed.
jumper installed.