Seagate ST32430N/ND ユーザーズマニュアル
28 Hawk 2LP Family Installation Guide, Rev. B
_____________________________________________________________________________________________________________
continued from previous page
TP Position A ("N" family models only)
On
On
This horizontally positioned jumper across the
two TP positions nearest PCB edge, connects
terminator power from SCSI bus I/O pin 26 to
the drive's internal terminators.
two TP positions nearest PCB edge, connects
terminator power from SCSI bus I/O pin 26 to
the drive's internal terminators.
Off
See above explanations for TP jumpers.
J5 Jumper
Jumper Function Description
Installation ("N" and "ND" models only)
A
0
,
A
1
,
A
2
Drive ID on SCSI Bus (J6 may be used in-
stead). The drive ID is binary coded positionwise
i.e., jumper in position A
stead). The drive ID is binary coded positionwise
i.e., jumper in position A
2
is drive ID 4, in
position A
1
is ID 2, position A
0
is ID 1 and no
jumpers is ID 0. Default is ID = 0.
J6 Jumper
Installation Jumper Function Description
Installation Jumper Function Description
A
2
,
A
1
,A
0
Drive ID on SCSI bus. On "N" and "ND" models,
either J5 or J6 (optional) may be used to select
drive ID. Both should not be used at the same
time, because at some future time when the ID
is changed the user could fail to configure both
J5 and J6 the same. Default is ID = 0.
either J5 or J6 (optional) may be used to select
drive ID. Both should not be used at the same
time, because at some future time when the ID
is changed the user could fail to configure both
J5 and J6 the same. Default is ID = 0.