Seagate ST3450802SS ユーザーズマニュアル
Cheetah NS 10K.2 SAS Product Manual, Rev. C
25
6.4.2
Relative humidity
The values below assume that no condensation on the drive occurs.
a. Operating
5% to 95% non-condensing relative humidity with a maximum gradient of 20% per hour.
b. Non-operating
5% to 95% non-condensing relative humidity.
6.4.3
Effective altitude (sea level)
a. Operating
–1,000 to +10,000 feet (–305 to +3,048 meters)
b. Non-operating
–1,000 to +40,000 feet (–305 to +12,192 meters)
6.4.4
Shock and vibration
Shock and vibration limits specified in this document are measured directly on the drive chassis. If the drive is
installed in an enclosure to which the stated shock and/or vibration criteria is applied, resonances may occur
internally to the enclosure resulting in drive movement in excess of the stated limits. If this situation is apparent,
it may be necessary to modify the enclosure to minimize drive movement.
installed in an enclosure to which the stated shock and/or vibration criteria is applied, resonances may occur
internally to the enclosure resulting in drive movement in excess of the stated limits. If this situation is apparent,
it may be necessary to modify the enclosure to minimize drive movement.
The limits of shock and vibration defined within this document are specified with the drive mounted by any of
the four methods shown in Figure 6, and in accordance with the restrictions of Section 8.3.
the four methods shown in Figure 6, and in accordance with the restrictions of Section 8.3.
6.4.4.1
Shock
a. Operating—normal
The drive, as installed for normal operation, shall operate error free while subjected to intermittent shock not
exceeding:
exceeding:
• 15 Gs at a duration of 11 ms (half sinewave)
• 20 Gs at a duration of 2 ms (half sinewave)
• 60 Gs at a duration of 2 ms (half sinewave) when performing reads only
Shock may be applied in the X, Y, or Z axis. Shock is not to be repeated more than once every 2 seconds.
b. Operating—abnormal
Equipment, as installed for normal operation, does not incur physical damage while subjected to intermit-
tent shock not exceeding 40 Gs at a duration of 11 ms (half sinewave). Shock occurring at abnormal levels
may promote degraded operational performance during the abnormal shock period. Specified operational
performance will continue when normal operating shock levels resume. Shock may be applied in the X, Y,
or Z axis. Shock is not to be repeated more than once every 2 seconds.
tent shock not exceeding 40 Gs at a duration of 11 ms (half sinewave). Shock occurring at abnormal levels
may promote degraded operational performance during the abnormal shock period. Specified operational
performance will continue when normal operating shock levels resume. Shock may be applied in the X, Y,
or Z axis. Shock is not to be repeated more than once every 2 seconds.
c. Non-operating
The limits of non-operating shock shall apply to all conditions of handling and transportation. This includes
both isolated drives and integrated drives.
both isolated drives and integrated drives.
The drive subjected to nonrepetitive shock not exceeding the three values below, shall not exhibit device
damage or performance degradation.
damage or performance degradation.
• 80 Gs at a duration of 11 ms (half sinewave)
• 300 Gs at a duration of 2 ms (half sinewave)
• 150 Gs at a duration of 0.5 ms (half sinewave)
Shock may be applied in the X, Y, or Z axis.