Fujitsu TE988G ユーザーズマニュアル
Fujitsu TE988G Color Monitor
1
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and if
not installed and used in accordance with the instruction manual may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and if
not installed and used in accordance with the instruction manual may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
(1).
Reorient the receiving antenna.
(2).
Increase the separation between the equipment and receiver.
(3).
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
the receiver is connected.
(4).
Consult the dealer or an experienced radio TV technician for help.
Notice:
(1) The changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
(2) Shielded interference cables must be used in order to comply with the emission
limits.
Energy Declaration
This monitor is equipped with a function for saving of energy which supports the VESA
Display Power Management Signaling ( DPMS ) standard. This means that the monitor must
be connected to a computer which supports VESA DPMS to fulfill the requirement in the
NUTEK specification. Time settings are adjusted from the system unit by software. From
indicated inactivity to Power Saving Position A2 the total time must not be set to more than
70 minutes.
NUTEK
VESA State
LED Indicator
Power Consumption
Normal operation
ON
Green
120W (Max.)
Power Saving Position A1
SUSPEND
Orange
15W (Max.)
Power Saving Position A2
OFF
Orange-flash
5W (Max.)
We recommend you to switch off the monitor when it is not in use for quite a long time.