IBM XSERIES 220 ユーザーズマニュアル
102
Hardware Maintenance Manual: xSeries 220
To remove the system board, do the following:
1.
Power-off the server, if it is on.
2.
Unplug the server.
3.
Remove the cover (see “Removing the side cover” on page 59).
4.
Remove the front bezel (see “Removing the bezel” on page 60).
5.
Remove the support bracket (see “Removing the support bracket assembly” on
page 61).
page 61).
6.
Disconnect the cables.
7.
Remove the adapter cards and both adapter retaining brackets (see “Installing an
adapter” on page 65).
adapter” on page 65).
8.
Remove the hot-swap hard disk drive cage (see “Hot-swap hard disk drive cage”
on page 98).
on page 98).
9.
Remove memory modules (see “Installing memory modules” on page 76).
10. Remove microprocessors and/or terminator cards (see “Installing and removing
11. Remove screws and lift the system board out of the server.
CD-ROM drive
Before you begin:
•
•
Review the information in “Before you begin” on page 58.