Omron C200HE ユーザーズマニュアル

AR 2405 turns ON when the cycle time set with SCAN(18) is shorter than the
actual cycle time.

AR 2405 is refreshed every cycle while the PC is in RUN or MONITOR mode.

The following flags indicate when the specified Link Units are mounted to the
Racks. (Refer to 3-5-15 CPU Unit-mounting Device Mounted Flag for CPU Unit-
mounting Host Link Units.) These flags are refreshed every cycle.

SYSMAC LINK/SYSMAC NET Link Unit
Level 1 Mounted Flag

AR 2408

SYSMAC LINK/SYSMAC NET Link Unit in operating level 1

SYSMAC LINK/SYSMAC NET Link Unit
Level 0 Mounted Flag

AR 2409

SYSMAC LINK/SYSMAC NET Link Unit in operating level 0

Rack-mounting Host Link Unit Level 1

AR 2413

Rack-mounting Host Link Unit in operating level 1

Rack-mounting Host Link Unit Level 0

AR 2414

Rack-mounting Host Link Unit in operating level 0

AR 2415 turns ON when any device is mounted directly to the CPU Unit. This
includes CPU Unit-mounting Host Link Units, Programming Consoles, and In-
terface Units. This flag is refreshed every cycle.

AR 2508 is used to adjust the monitoring time of FPD(––) automatically. Refer to
5-25-12 FAILURE POINT DETECT – FPD(––) for details.

The following control bits and flags are used during data tracing with TRSM(45).
The Tracing Flag will be ON during tracing operations. The Trace Completed
Flag will turn ON when enough data has been traced to fill Trace Memory.

AR 2512

Trace Completed Flag

AR 2513

Tracing Flag

AR 2514

Trace Trigger Bit (writeable)

AR 2515

Sampling Start Bit (writeable)

Note Refer to 5-25-3 TRACE MEMORY SAMPLING – TRSM(45) for details.

AR 26 contains the maximum cycle time that has occurred since program execu-
tion was begun. AR 27 contains the present cycle time.

Both times are to tenths of a millisecond in 4-digit BCD (000.0 ms to 999.9 ms),
and are refreshed every cycle.