Campbell Manufacturing RF415 ユーザーズマニュアル

power and intermittent repeater sites may not be a problem.  Test
such a site with a representative setup before committing to it (see
Troubleshooting Section 6).  Keep in mind that commercial sites tend
to evolve.  Such a site may work now but could change in the future
with the addition of new equipment.

There are two ways of configuring the Setup map for a point-to-point
‘network.’  You can represent the RF400s in the Setup map or simply leave
them off.  The simple map usually results in a quicker connection and requires
less typing.

(1)  Point-to-point (not represented)

(a)  Setup map:

ComPort_1

CR10X

(2)  Point-to-point (represented)

(a)  Setup map:

ComPort_1

RF400

RF400Remote

CR10X

(3)  The station’s Maximum Baud Rate is typically 9600

(4)  Extra Response Times are typically 0 s

In the case of point-to-multipoint, the RF400s are always represented in the
LoggerNet Setup map so that LoggerNet can temporarily change the base
RF400’s Radio Address to communicate with one out of a group of remote
RF400s.

(1)  Point-to-multipoint

(a)  Setup map:

ComPort_1

RF400

RF400Remote_1

CR10X_1

RF400Remote_2

CR10X_2

RF400Remote_3

CR10X_3

(2)  All RF400Remotes have the same Network Address but each

RF400Remote must have a unique Radio Address.

(3)  Extra Response Times are typically 0 s