MRV Communications TS5000/4U1/V*) ユーザーズマニュアル

M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l

Typical Connection

1 - Fiber Connection

In order to implement a connection, each transceiver must be connected to the
peripheral/testing equipment through fiber optic cables. A correct connection is
notified by the display on the back panel of the transceiver (see the section Display
and Results pages 37 - 38).

IT IS A CROSS CONNECTION:

TX RX AND

RX TX

Peripheral/Testing

Equipment

UWIN

Peripheral/Testing

Equipment

UWIN

IR link

Figure 1.14: Typical Connection for Models 155 and 155-F

2 - Copper Connection

In order to implement a connection, each transceiver must be connected to the
peripheral/testing equipment through a 2 pairs STP cable. A correct connection is
notified by the display on the back panel of the transceiver (see the section Display
and Results pages 37 and 38).

IR link

Peripheral/Testing

Equipment

UWIN

10BaseT

STP

cable

Peripheral/Testing

Equipment

UWIN

10BaseT

STP

cable

Figure 1.15: Typical Connection for Models ETH and 4U1 (4E1 or 4T1)

For 4E1/4T1 the 4 channels (or less as required) are to be connected separately.

When testing the model 4U1 (4E1 or 4T1), the matching ports on the two TS5000
heads must be connected, for e.g, if Channel A is connected on one head, Channel
A must be connected on the other head as well.

Scheme of the

Connection

to peripheral equipment

Scheme of the

Connection

to the peripheral
equipment