MRV Communications TS5000/XXX (TS5000G/XYZ/V** ユーザーズマニュアル
M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l
40
Installation
This chapter deals with the mounting of the hardware and the
unit on the site (see Appendix D for the required material).
unit on the site (see Appendix D for the required material).
See Unpacking Instructions in Appendix C
.
CAUTION: Unit to be mounted in horizontal position only. Max angle 45
o
Accessories
The standard mounting accessories are supplied with the transceiver in a kit. They
are designed for typical mounting on horizontal and vertical surfaces.
Description
The accessories kit (supplied by MRV) consists of :
are designed for typical mounting on horizontal and vertical surfaces.
Description
The accessories kit (supplied by MRV) consists of :
o
The Mounting Plate (JMP-8)
o
The Alignment Device (AD-5000)
o
The Installer Tool Kit (JITK-8)
The JMP-8 is used for mounting the transceiver on the support surface. (i.e. to a
horizontal concrete surface/plate only) the JMP-8 is not fit to the MRV standard
mounting brackets, if needed to mount it on MRV standard mounting brackets,
attach the AD5000 base plate directly to the mounting bracket top plate without
the JMP-8
The AD-5000 allows the aiming of the two units making the link (see chapter 6)
horizontal concrete surface/plate only) the JMP-8 is not fit to the MRV standard
mounting brackets, if needed to mount it on MRV standard mounting brackets,
attach the AD5000 base plate directly to the mounting bracket top plate without
the JMP-8
The AD-5000 allows the aiming of the two units making the link (see chapter 6)
Chapter
5
JMP-8
Mounting Plate
(dimensions in mm)
Dimensions in mm
A: Screw for
grounding
grounding
Figure 5.1a: JMP-8
Figure 5.1b: JMP-8