Motorola CPCI-6020 ユーザーズマニュアル
Installing and Removing a Module
Hardware Preparation and Installation
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
51
2.13
Installing and Removing a Module
This section describes a recommended procedure for installing and removing a board module
in a chassis. Before you install your module, please read all cautions, warnings and instructions
presented in this section and the guidelines explained in
in a chassis. Before you install your module, please read all cautions, warnings and instructions
presented in this section and the guidelines explained in
.
Installation Procedure
Hot swap compliant modules may be installed while the system is powered on. If a module is
not hot swap compliant, you should remove power to the slot or system before installing the
module. See
not hot swap compliant, you should remove power to the slot or system before installing the
module. See
for more information.
Signaling Requirements
Ensure the backplane does not bus J3, J4 or J5 signals to other slots.
Set the VIO on the backplane to either +3.3 V or +5 V, depending upon your system’s
signaling requirements.
Ensure the backplane does not bus J3, J4 or J5 signals to other slots.
Set the VIO on the backplane to either +3.3 V or +5 V, depending upon your system’s
signaling requirements.