Cypress CY7C602xx ユーザーズマニュアル
CY7C601xx, CY7C602xx
Document 38-16016 Rev. *E
Page 29 of 68
12.2.6 LPOSC Trim
12.3 CPU Clock During Sleep Mode
When the CPU enters sleep mode the CPUCLK Select (Bit 0,
) is forced to the internal oscillator, and the oscillator is
stopped. When the CPU comes out of sleep mode it runs on the internal oscillator. The internal oscillator recovery time is three
clock cycles of the internal 32 kHz low power oscillator.
clock cycles of the internal 32 kHz low power oscillator.
If the system requires the CPU to run off the external clock after waking from sleep mode, firmware needs to switch the clock
source for the CPU. If the external clock source is the external oscillator and the oscillator is disabled, firmware needs to enable
the external oscillator, wait for it to stabilize, and then change the clock source.
source for the CPU. If the external clock source is the external oscillator and the oscillator is disabled, firmware needs to enable
the external oscillator, wait for it to stabilize, and then change the clock source.
Table 12-8. LPOSC Trim (LPOSCTR) [0x36] [R/W]
Bit #
7
6
5
4
3
2
1
0
Field
32 kHz Low
Power
Reserved
32 kHz Bias Trim [1:0]
32 kHz Freq Trim [3:0]
Read/Write
R/W
–
R/W
R/W
R/W
R/W
R/W
R/W
Default
0
–
D
D
D
D
D
D
This register is used to calibrate the 32 kHz low speed oscillator. The reset value is undefined but during boot the SROM writes
a calibration value that is determined during manufacturing test. This is the meaning of ‘D’ in the Default field. The trim value is
adjusted vs. voltage as noted in
a calibration value that is determined during manufacturing test. This is the meaning of ‘D’ in the Default field. The trim value is
adjusted vs. voltage as noted in
Bit 7: 32 kHz Low Power
0 = The 32 kHz low speed oscillator operates in normal mode.
1 = The 32 kHz low speed oscillator operates in a low power mode. The oscillator continues to function normally but with reduced
accuracy.
Bit 6: Reserved
Bit [5:4]: 32 kHz Bias Trim [1:0]
These bits control the bias current of the low power oscillator.
0 0 = Mid bias
0 1 = High bias
1 0 = Reserved
1 1 = Reserved
Note Do not program the 32 kHz Bias Trim [1:0] field with the reserved 10b value as the oscillator does not oscillate at all corner
conditions with this setting.
Bit [3:0]: 32 kHz Freq Trim [3:0]
These bits are used to trim the frequency of the low power oscillator.
0 = The 32 kHz low speed oscillator operates in normal mode.
1 = The 32 kHz low speed oscillator operates in a low power mode. The oscillator continues to function normally but with reduced
accuracy.
Bit 6: Reserved
Bit [5:4]: 32 kHz Bias Trim [1:0]
These bits control the bias current of the low power oscillator.
0 0 = Mid bias
0 1 = High bias
1 0 = Reserved
1 1 = Reserved
Note Do not program the 32 kHz Bias Trim [1:0] field with the reserved 10b value as the oscillator does not oscillate at all corner
conditions with this setting.
Bit [3:0]: 32 kHz Freq Trim [3:0]
These bits are used to trim the frequency of the low power oscillator.