Cypress CY7C63310 ユーザーズマニュアル
CY7C63310, CY7C638xx
Document 38-08035 Rev. *K
Page 80 of 83
32. Document History Page
Document Title: CY7C63310, CY7C638xx enCoRe
™ II Low Speed USB Peripheral Controller
Document Number: 38-08035
Rev.
ECN No.
Orig. of
Change
Submission
Date
Description of Change
**
131323
XGR
12/11/03
New data sheet
*A
221881
KKU
See ECN
Added Register descriptions and package information, changed from advance
information to preliminary
*B
271232
BON
See ECN
Reformatted. Updated with the latest information
*C
299179
BON
See ECN
Corrected 24-PDIP pinout typo in
Updated
53. and
on page 41. Added various updates to the GPIO Section
.
Added the
16-pin PDIP package diagram (section
*D
322053
TVR
BON
See ECN
on page 3: Removed Low-voltage reset in last paragraph. There
is no LVR, only LVD (Low voltage detect). Explained more about LVD and POR.
Changed capture pins from P0.0,P0.1 to P0.5,P0.6.
on page 7: Changed table heading (Removed Mnemonics and made
as Register names).
on page 16: Included #of rows for different flash sizes.
on page 21: Changed CPUCLK selectable
options from n=0-5,7,8 to n=0-5,7.
on page 19: Changed ITMRCLK division to 1,2,3,4. Updated the
sources to ITMRCLK, TCAPCLKs. Mentioned P17 is TTL enabled permanently.
Corrected FRT, PIT data write order. Updated INTCLR, INTMSK registers in
the register table also.
on page 68: changed LVR to LVD included max min
programmable trip points based on char data. Updated the 50ma sink pins on
638xx, 63903. Keep-alive voltage mentioned corresponding to Keep-alive
current of 20uA. Included Notes regarding VOL,VOH on P1.0,P1.1 and TMDO
spec.
MDO1
, T
SDO1
In description column changed
Phase to 0.
on page 4: Removed the VREG from the CY7C63310 and CY7C63801
Removed SCLK and SDATA. Created a separate pinout diagram for the
CY7C63813.
Added the GPIO Block Diagram (
on page 23: Changed the Sleep Timer Clock unit from 32 kHz count
to Hz.
on page 58: Added more descriptions to the register.
*E
341277
BHA
See ECN
Corrected V
IH
TTL value in
Updated V
IL
TTL value.
Added footnote to pin description table for D+/D– pins.
Added Typical Values to Low Voltage Detect table.
Corrected Pin label on 16-pin PDIP package.
Corrected minor typos.
*F
408017
TYJ
See ECN
on page 6: Corrected pin assignment for the 24-pin QSOP package
- GPIO port 3
New Assignments: Pin 19 assigned to P3.0 and pin 20 to P3.1
on page 54: INT_MASK1 changed to 0xE1
on page 55: INT_MASK0 changed to 0xE0
on page 64: Register Summary, address E0 assigned to
INT_MASK0 and address E1 assigned to INT_MASK1