Nortel Networks 4050 ユーザーズマニュアル
66 Chapter 2 Initial setup
320818-A
12 Wait while the Setup utility finishes processing. When processing is complete,
you will see
Setup successful.
The new Nortel SNAS 4050 automatically picks up all other required
configuration data from the existing Nortel SNAS 4050 in the cluster. After a
short while, you receive the
configuration data from the existing Nortel SNAS 4050 in the cluster. After a
short while, you receive the
login
prompt.
Next steps
1
To enable the SREM connection to the Nortel SNAS 4050:
a
Use the
/cfg/sys/adm/ssh on
command to enable SSH access to the
Nortel SNAS 4050 (for more information, see
b
Use the
/cfg/sys/adm/srsadmin ena
command to enable
TunnelGuard SRS administration (for more information, see
).
From this point on, you can configure the Nortel SNAS 4050 using either the
CLI or the SREM.
CLI or the SREM.
2
To enable remote management using Telnet, use the
/cfg/sys/adm/
telnet on
command to enable Telnet access to the Nortel SNAS 4050 (for
more information, see
Note: For greater security, you may want to restrict access to the Nortel
SNAS 4050 to those machines specified in an Access List. In this case,
ensure that you add an IP address for the SREM to the Access List. For
more information about using the Access List to control Telnet and SSH
access, see
SNAS 4050 to those machines specified in an Access List. In this case,
ensure that you add an IP address for the SREM to the Access List. For
more information about using the Access List to control Telnet and SSH
access, see
or
Setup successful.
login: