Nxp Semiconductors UM10237 ユーザーズマニュアル
UM10237_2
© NXP B.V. 2008. All rights reserved.
User manual
Rev. 02 — 19 December 2008
78 of 792
NXP Semiconductors
UM10237
Chapter 5: LPC24XX External Memory Controller (EMC)
10.3 EMC Configuration register (EMCConfig - 0xFFE0 8008)
The EMCConfig register configures the operation of the memory controller. It is
recommended that this register is modified during system initialization, or when there are
no current or outstanding transactions. This can be ensured by waiting until the EMC is
idle, and then entering low-power, or disabled mode. This register is accessed with one
wait state.
recommended that this register is modified during system initialization, or when there are
no current or outstanding transactions. This can be ensured by waiting until the EMC is
idle, and then entering low-power, or disabled mode. This register is accessed with one
wait state.
shows the bit assignments for the EMCConfig register.
10.4 Dynamic Memory Control register (EMCDynamicControl -
0xFFE0 8020)
The EMCDynamicControl register controls dynamic memory operation. The control bits
can be altered during normal operation.
can be altered during normal operation.
shows the bit assignments for the
EMCDynamicControl register.
Table 70.
EMC Configuration register (EMCConfig - address 0xFFE0 8008) bit description
Bit
Symbol
Value Description
Reset
Value
Value
0
Endian mode:
0
0
Little-endian mode (POR reset value).
1
Big-endian mode.
On power-on reset, the value of the endian bit is 0. All
data must be flushed in the EMC before switching
between little-endian and big-endian modes.
data must be flushed in the EMC before switching
between little-endian and big-endian modes.
7:1
-
-
Reserved, user software should not write ones to reserved
bits. The value read from a reserved bit is not defined.
bits. The value read from a reserved bit is not defined.
NA
8
CCLK : CLKOUT[1:0] ratio:
0
0
1:1 (POR reset value)
1
1:2 (this option is not available on the LPC2400)
This bit must contain 0 for proper operation of the EMC.
31:9 -
-
Reserved, user software should not write ones to reserved
bits. The value read from a reserved bit is not defined.
bits. The value read from a reserved bit is not defined.
NA
Table 71.
Dynamic Control register (EMCDynamicControl - address 0xFFE0 8020) bit
description
description
Bit
Symbol
Value Description
Reset
Value
Value
0
Dynamic
memory clock
enable (CE)
memory clock
enable (CE)
0
Clock enable of idle devices are deasserted to save
power (POR reset value).
power (POR reset value).
0
1
All clock enables are driven HIGH continuously.
1
Dynamic
memory clock
control (CS)
memory clock
control (CS)
0
CLKOUT stops when all SDRAMs are idle and during
self-refresh mode.
self-refresh mode.
1
1
CLKOUT runs continuously (POR reset value).
When clock control is LOW the output clock CLKOUT is
stopped when there are no SDRAM transactions. The
clock is also stopped during self-refresh mode.
stopped when there are no SDRAM transactions. The
clock is also stopped during self-refresh mode.