RAD Data comm IPmux-1 ユーザーズマニュアル
IPmux-1/1E Installation and Operation Manual
Chapter 1 Introduction
Technical Specifications
1-27
Signal Levels
Jitter Performance
Receive: 0 to –10 dB
Transmit: ±2.7V ± 10%, adjustable, measured in range
Transmit: ±2.7V ± 10%, adjustable, measured in range
0 to 133 feet, without CSU
AT&T TR-62411, G.824 standards
AT&T TR-62411, G.824 standards
Indicators
General:
PWR
ON when power supply is OK
OFF when a malfunction is detected
OFF when a malfunction is detected
RDY
ON when self-test is successfully completed
OFF during self-test
OFF during self-test
BLINKS when self-test fails
Ethernet Port:
LINK
OFF when line is not active
ON when line is OK
ON when line is OK
ACT
OFF when no activity
ON when a frame is being transmitted or
received on the line
received on the line
100M OFF when 10 MHz
ON when 100 MHz
FDX
OFF when half duplex
ON when full duplex
ON when full duplex
E1/T1 Port:
SYNC ON when the port is synchronized (no alarm)
OFF when signal loss, LOF or AIS is detected
(local alarm)
(local alarm)
BLINKS when RDI is detected (remote alarm)
ISDN Port:
SYNC ON when the ISDN BRI frame is
synchronized (no alarm)
OFF when signal loss, LOF is detected
OFF when signal loss, LOF is detected
FXS Port:
SYNC ON when off-hook
OFF when on-hook
BLINKS when ringing
BLINKS when ringing
Note: All LEDs are green and ON after power-up.
Power
1 power supply
100 to 240 VAC, 50 or 60 Hz
–36 to –72 VDC (–48 VDC nominal)
Note: IPmux-1E only has AC power supply option.
–36 to –72 VDC (–48 VDC nominal)
Note: IPmux-1E only has AC power supply option.
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com