Zhone Technologies Z-PLEX-10-24-DOC-SC ユーザーズマニュアル
Zhone Technologies / 1-3
Introduction
Managing the Z-Plex
When a T1 port is configured for TR-08 format, the voice channels assigned to this port are
identified by channel number (according to the TR-TSY-000008 document), which may be
different from the T1 time slot number. The product supports only Shelf A. The relation
between a channel number and corresponding slot number for TR-08 is shown in the
following table.
identified by channel number (according to the TR-TSY-000008 document), which may be
different from the T1 time slot number. The product supports only Shelf A. The relation
between a channel number and corresponding slot number for TR-08 is shown in the
following table.
1.5
Managing the Z-Plex
The Z-Plex provides the following interfaces to configure the unit:
•
Serial (craft)—An out-of-band RS232 serial interface.
•
DS0—The DS0 management channel encapsulates IP traffic in HDLC frames using DS0
24.
24.
•
Ethernet —You can telnet to the Z-Plex over the Ethernet to manage the unit.
•
IP over FDL —The Z-Plex unit supports IP over FDL as a way to configure the system
via the CLI. The IP over FDL connection is different than the standard FDL interface
which provides error checking for T1 interfaces. The two FDL interfaces cannot be used
at the same time.
via the CLI. The IP over FDL connection is different than the standard FDL interface
which provides error checking for T1 interfaces. The two FDL interfaces cannot be used
at the same time.
You can configure the Z-Plex using any of the following methods:
•
SNMP
•
CLI
•
TFTP
1.5.1
SNMP
The Z-Plex supports Simple Network Management Protocol (SNMP) version 1 and version 2
for system management. Network object variables are management information base II
(MIB-II) compliant.
for system management. Network object variables are management information base II
(MIB-II) compliant.
SNMP can be accessed over a number of IP interfaces, including IP over FDL, the DS0 24
management channel, or the Ethernet interface. The SNMP agent on the Z-Plex uses to port
161 of UDP for management traffic and UDP port 162 for error events and SNMP traps.
management channel, or the Ethernet interface. The SNMP agent on the Z-Plex uses to port
161 of UDP for management traffic and UDP port 162 for error events and SNMP traps.
The MIBs for the Z-Plex control the following:
Channel
Numbers
Numbers
1
2
3
4
5
6
7
8
9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Time slots
1
3
5
7
9 11 13 15 17 19 21 23 2
4
6
8 10 12 14 16 18 20 22 24