Mitsubishi Electronics 13JW55 ユーザーズマニュアル
7 - 19
7.6.3 List of I/O signals and buffer memory assignment
(1) List of I/O signals
The following shows a list of the I/O signals for the D/A converter modules.
The following explanation is mentioned based on the Q68DAVN, Q68DAIN,
Q68DAV and Q68DAI with 8-channel analog output (CH1 to CH8).
Note that I/O numbers (X/Y) shown in this section and thereafter are the values
when the start I/O number for the D/A converter module is set to 0.
Signal
direction
D/A converter module
→ CPU module
Signal
direction
CPU module
→ D/A converter module
Device No.
Signal name
Device No.
Signal name
X0
Module READY
Y0
Use prohibited
*1
X1
Y1
CH1 Output enable/disable flag
X2
Y2
CH2 Output enable/disable flag
X3 Y3
*2
CH3 Output enable/disable flag
X4 Y4
*2
CH4 Output enable/disable flag
X5 Y5
*2
CH5 Output enable/disable flag
X6 Y6
*2
CH6 Output enable/disable flag
X7
Use prohibited
*1
Y7
*2
CH7 Output enable/disable flag
X8
High resolution mode status flag
Y8
*2
CH8 Output enable/disable flag
X9
Operating condition setting completed flag
Y9 Operating
condition setting request
XA
Offset/gain setting mode flag
YA
User range writing request
XB
Channel change completed flag
YB
Channel change request
XC
Set value change completed flag
YC
Set value change request
XD
Synchronous output mode flag
YD
Synchronous output request
XE Use
prohibited
*1
YE
Use
prohibited
*1
XF
Error flag
YF
Error clear request
POINT
*1: These signals cannot be used by the user since they are for system use only.
If these are turned on/off by the sequence program, the functioning of the D/A
converter module cannot be guaranteed.
converter module cannot be guaranteed.
*2: For the Q62DAN and Q62DA, the use of Y3 to Y8 is prohibited.
For the Q64DAN and Q64DA, the use of Y5 to Y8 is prohibited.