Motorola MCF5281 ユーザーズマニュアル
MOTOROLA
Chapter 22. Queued Serial Peripheral Interface (QSPI) Module
22-15
Programming Model
22.5.7 Command RAM Registers (QCR0–QCR15)
The command RAM is accessed using the upper byte of QDR. The QSPI cannot modify
information in command RAM.
information in command RAM.
There are 16 bytes in the command RAM. Each byte is divided into two fields. The chip
select field enables external peripherals for transfer. The command field provides transfer
operations.
select field enables external peripherals for transfer. The command field provides transfer
operations.
NOTE
The command RAM is accessed only using the most
significant byte of QDR and indirect addressing based on
QAR[ADDR].
significant byte of QDR and indirect addressing based on
QAR[ADDR].
15
14
13
12
11
8
7
0
Field CONT
BITSE
DT
DSCK
QSPI_CS
–
Reset
Undefined
R/W
Write Only
Address
QAR[ADDR]
Figure 22-10. Command RAM Registers (QCR0–QCR15)
Table 22-8. QCR0–QCR15 Field Descriptions
Bits
Name
Description
15
CONT
Continuous.
0 Chip selects return to inactive level defined by QWR[CSIV] when transfer is complete.
1 Chip selects remain asserted after the transfer of 16 words of data (see note below).
0 Chip selects return to inactive level defined by QWR[CSIV] when transfer is complete.
1 Chip selects remain asserted after the transfer of 16 words of data (see note below).
14
BITSE
Bits per transfer enable.
0 Eight bits
1 Number of bits set in QMR[BITS]
0 Eight bits
1 Number of bits set in QMR[BITS]
13
DT
Delay after transfer enable.
0 Default reset value.
1 The QSPI provides a variable delay at the end of serial transfer to facilitate interfacing with
0 Default reset value.
1 The QSPI provides a variable delay at the end of serial transfer to facilitate interfacing with
peripherals that have a latency requirement. The delay between transfers is determined by
QDLYR[DTL].
QDLYR[DTL].
12
DSCK
Chip select to QSPI_CLK delay enable.
0 Chip select valid to QSPI_CLK transition is one-half QSPI_CLK period.
1 QDLYR[QCD] specifies the delay from QSPI_CS valid to QSPI_CLK.
0 Chip select valid to QSPI_CLK transition is one-half QSPI_CLK period.
1 QDLYR[QCD] specifies the delay from QSPI_CS valid to QSPI_CLK.
11–8
QSPI_CS
Peripheral chip selects. Used to select an external device for serial data transfer. More than one chip
select may be active at once, and more than one device can be connected to each chip select. Bits
11–8 map directly to QSPI_CS[3:0], respectively. If it is desired to use those bits as a chip select
value, then an external demultiplexor must be connected to the QSPI_CS[3:0] pins.
select may be active at once, and more than one device can be connected to each chip select. Bits
11–8 map directly to QSPI_CS[3:0], respectively. If it is desired to use those bits as a chip select
value, then an external demultiplexor must be connected to the QSPI_CS[3:0] pins.
7–0
—
Reserved, should be cleared.