Motorola MCF5282 ユーザーズマニュアル

29-12

MOTOROLA

 

The DBR, shown in Figure 29-8, specifies data patterns used as part of the trigger into
debug mode. DBR bits are masked by setting corresponding DBMR bits, as defined in
TDR.

7

—

Reserved, should be cleared.

6

NPL

Non-pipelined mode. Determines whether the core operates in pipelined or mode or not.
0 Pipelined mode
1 Nonpipelined mode. The processor effectively executes one instruction at a time with no overlap. This 

adds at least 5 cycles to the execution time of each instruction. Given an average execution latency of 1.6 

cycles/instruction, throughput in non-pipeline mode would be 6.6 cycles/instruction, approximately 25% 
or less of pipelined performance.

Regardless of the NPL state, a triggered PC breakpoint is always reported before the triggering instruction 
executes. In normal pipeline operation, the occurrence of an address and/or data breakpoint trigger is 
imprecise. In non-pipeline mode, triggers are always reported before the next instruction begins execution 
and trigger reporting can be considered precise.

5

IPI

Ignore pending interrupts. 
1  Core ignores any pending interrupt requests signalled while in single-instruction-step mode.
0  Core services any pending interrupt requests that were signalled while in single-step mode.

4

SSM

Single-step mode. Setting SSM puts the processor in single-step mode.
0 Normal mode.
1 Single-step mode. The processor halts after execution of each instruction. While halted, any BDM 

command can be executed. On receipt of the 

GO

 command, the processor executes the next instruction and 

halts again. This process continues until SSM is cleared. 

3–0

—

Reserved, should be cleared.

31

0

Field

Data (DBR); Mask (DBMR)

Reset

Uninitialized

R/W DBR is accessible in supervisor mode as debug control register 0x0E, using the WDEBUG instruction and through the 

BDM port using the 

RDMREG

 and 

WDMREG

 commands.

DBMR is accessible in supervisor mode as debug control register 0x0F,using the WDEBUG instruction and via the 
BDM port using the 

WDMREG

 command.

DRc[4–0]

0x0E (DBR), 0x0F (DBMR)