Motorola MCF5282 ユーザーズマニュアル
29-14
MCF5282 User’s Manual
MOTOROLA
Programming Model
29.4.7 Trigger Definition Register (TDR)
The TDR, shown in Table 29-11, configures the operation of the hardware breakpoint logic
that corresponds with the ABHR/ABLR/AATR, PBR/PBMR, and DBR/DBMR registers
within the debug module. The TDR controls the actions taken under the defined conditions.
Breakpoint logic may be configured as a one- or two-level trigger. TDR[31–16] define the
second-level trigger and bits 15–0 define the first-level trigger.
that corresponds with the ABHR/ABLR/AATR, PBR/PBMR, and DBR/DBMR registers
within the debug module. The TDR controls the actions taken under the defined conditions.
Breakpoint logic may be configured as a one- or two-level trigger. TDR[31–16] define the
second-level trigger and bits 15–0 define the first-level trigger.
31
0
Field
Program Counter
Reset
—
R/W Write. PC breakpoint register is accessible in supervisor mode using the WDEBUG instruction and through the BDM
port using the
RDMREG
and
WDMREG
commands using values shown in Section 29.5.3.3, “Command Set
DRc[4–0]
0x08
Figure 29-9. Program Counter Breakpoint Register (PBR)
Table 29-12. PBR Field Descriptions
Bits
Name
Description
31–0
Address
PC breakpoint address. The 32-bit address to be compared with the PC as a breakpoint trigger.
31
0
Field
Mask
Reset
—
R/W Write. PBMR is accessible in supervisor mode as debug control register 0x09 using the WDEBUG instruction and
via the BDM port using the wdmreg command.
DRc[4–0]
0x09
Figure 29-10. Program Counter Breakpoint Mask Register (PBMR)
Table 29-13. PBMR Field Descriptions
Bits
Name
Description
31–0
Mask
PC breakpoint mask. A zero in a bit position causes the corresponding PBR bit to be compared to the
appropriate PC bit. Set PBMR bits cause PBR bits to be ignored.
appropriate PC bit. Set PBMR bits cause PBR bits to be ignored.