Multi-Tech Systems MTS2SA-T ユーザーズマニュアル

ページ / 181
Chapter 10 
− Modem Mode AT Commands, S-Registers, and Result Codes 
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 
106
 
 
Command: 
+MR     Modulation Reporting Control 
(Not available in V.22bis) 
Values: 
 
0, 1, 2 
Default:   0 
Description: 
This extended-format numeric parameter controls whether or not the extended-format 
+MCR:<carrier> and +MRR:<rate> intermediate result codes are transmitted from the 
modem to the DTE. If enabled, +MCR:<carrier> and +MRR:<rate> intermediate result codes 
represent the current (negotiated or renegotiated) modulation <carrier> and <rate> that are 
transmitted at the point during connect negotiation (handshaking) at which the modem has 
determined which modulation and rate will be used, i.e., before any Error Control or Data 
Compression reports are transmitted, and before any final result code (e.g., CONNECT) is 
transmitted. 
 
S95 bit 2 is reset to 0 for +MR=0 and is set to a 1 for +MR=1 or +MR=2. The more recent 
setting of +MR or S95 bit 2, and the W command setting, determines modulation result code 
reporting (see S95 Parameter and W Command). 
 
+MR0  Disables reporting of modulation connection (+MCR: and +MRR: are not transmitted).  
 
+MR1  Enables reporting of modulation connection (+MCR: and +MRR: are transmitted 
with tx rate, rx rate). 
 
+MR2  Enables reporting of modulation connection (+MCR: and +MRR: are transmitted 
with rx rate only). 
Reporting Current or Selected Values 
Command: +MR? 
Reporting Supported Range of Parameter Values 
Command: +MR=? 
Report Syntax   +MCR   
Response:  +MCR: <carrier> 
<carrier> 
Alphanumeric code corresponding to the reported carrier. Defined values are: 
B103 
For Bell 103 
B212 
For Bell 212 
V21 For 
V.21 
V22 For 
V.22 
V22B For 
V.22bis 
V23C For 
V.23 
V32 For 
V.32 
V32B For 
V.32bis 
V34 For 
V.34 
V90 For 
V.90 
K56 For 
K56flex 
Report Syntax   +MRR  
Response: +MRR: <tx_rate>,<rx_rate> 
<tx_rate>
 
Decimal transmit rate in bits/s. 
<rx_rate>
 
Decimal receive rate in bits/s. 
Example: 
+MRR: 28800, 48000