Multi-Tech Systems MTS2SA-T ユーザーズマニュアル

Chapter 16 – SNTP Client 

Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 

 

 

This scenario describes the updating of time from the NTP server with Daylight Savings Mode disabled. 

The MultiConnect IP time and date are updated with the time specified by the 
server and with the time-zone offset added to the time. 

SNTP client should send periodic requests to the server for the time update 
function depending on the polling time. 

1. Mandatory configuration. 

set sntp-client enable

 

Use "show date" or "show time" commands to check. 
Time and Date should be synchronized with the server. 
OK

 

 
 

This scenario describes the updating of time from the NTP server with Daylight Savings Mode enabled. 

The MultiConnect IP time and date are updated with the time specified by the 
server and with the daylight offset added to the time if the time falls between start 
and end configuration. 

SNTP client should send periodic requests to the server for the time update 
function depending on the polling time. 

1. Mandatory configuration. 
2. Optional configuration. 

set sntp-client enable

 

Use "show date" or "show time" commands to check. 
Time and Date should be synchronized with the server. 
OK

 

When the server cannot be reach or is not running, the SNTP client tries to reach the server every 10 
seconds for 6 times and waits for the polling time, and then it tries again to reach the server as 
before.