Multi-Tech Systems MTS2SA-T ユーザーズマニュアル

Chapter 7 – Telnet Dialout  

Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 

 

 

# set ip telnet auto-dialout enable 

# set ip telnet raw-mode enable 

 

# set serial s0 stop-bits 1 

# set serial s0 baud-rate 115200 

# set serial s0 data-bits 8 

# set serial s0 parity none 

# set serial s0 flow-control rts-cts 

 

# set serial s0 auto-dialout enable 

# set serial s0 raw-dialout enable 

# set serial s0 auto-dialout-port 5000 

# set serial s0 auto-dialout-protocol telnet 

 

# set serial s1 stop-bits 1 

# set serial s1 baud-rate 115200 

# set serial s1 data-bits 8 

# set serial s1 parity none 

# set serial s1 flow-control rts-cts 

# set serial s1 connect-type modem 

# set serial s1 modem dial-number 123 

 

# set serial s1 modem dialing-trig-mode none 

(Refer to Chapter 6 – Prerequisite Configurations - Physical Link Established over the Modem 

Port for more details) 

 

# set ppp ppp0 ipcp-mode client-only 

# set ppp ppp0 username "MultiConnect" 

# set ppp ppp0 password "MultiConnect" 

# save 

 

Once the physical link is up and PPP interface has acquired an IP address the  

MultiConnect IP is ready to accept Auto dialout connection.  

Use a Telnet client and connect to 202.54.39.95 on port 5000 (RAW TCP socket). This eventually 

establishes a Telnet auto-dial-out session (In RAWMODE) with the MultiConnect IP, thereby 
opening the serial port for use. 

Closing the Telnet client closes the serial port in use. 
 

You cannot open more than one dialout session to the same port.  

When the Dialout session authentication is enabled as specified in the 

Optional Configuration 

Commands

, the session prompts for a user name and password before opening the session 

successfully. 

The serial port is opened with the current serial configuration.