Cisco Systems AS5350XM ユーザーズマニュアル
3-5
Cisco AS5350XM Universal Gateway Chassis Installation Guide
OL-6417-02
Chapter 3
Installing the Cisco AS5350XM Universal Gateway
Setting Up the Chassis
Installing in a Rack
Caution
Do not use the handles on the dial feature cards to assist in lifting the chassis.
To install the chassis into the equipment rack, follow this procedure:
Step 1
With the mounting brackets attached to the chassis, support the chassis and align the holes in the brackets
with the screw holes in the rack. (See
with the screw holes in the rack. (See
Step 2
Attach the chassis to the rack with the screws you have provided. (See
Figure 3-4
Attaching the Chassis to a 19-Inch Rack—Rear Panel Forward
Connecting the Chassis Ground
You must connect the chassis to a reliable earth ground using the ground lug (provided) and size AWG 6
(13 mm
(13 mm
2
) wire.
To attach the chassis ground, take the following steps:
Step 1
Strip one end of the ground wire to expose approximately 0.75 in. (20 mm) of conductor.
Step 2
Crimp the ground wire to the ground lug, using a crimp tool of the appropriate size.
Step 3
Attach the ground lug to the chassis. (See
.) Use a medium flat-blade screwdriver and the
screws supplied with the ground lug. Tighten the screws to a torque of 8 to 10 in-lb (0.9 to 1.1 N-m).
Step 4
Connect the other end of the ground wire to a suitable grounding point at your site.
35659
Note: The second bracket attaches to the rack at the other side
of the chassis. The chassis can also be installed with the
front panel forward.
front panel forward.