Cisco Systems ONS 15600 ユーザーズマニュアル
11-3
Cisco ONS 15600 Procedure Guide, R5.0
February 2008
Chapter 11 Change Card Settings
NTP-E151 Provision an Optical Line Rate
NTP-E151 Provision an Optical Line Rate
Step 1
Complete the
to log into an ONS 15600 on the network.
Step 2
Click the Alarms tab:
a.
Verify that the alarm filter is not turned on. See the
as necessary.
b.
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15600 SONET Troubleshooting Guide.
resolve them before continuing. Refer to the Cisco ONS 15600 SONET Troubleshooting Guide.
c.
Complete the
to export alarm and condition
information.
Step 3
In node view, double-click the ASAP card where you want to provision the line rate.
Step 4
Click the Provisioning > Pluggable Port Modules tabs.
Step 5
In the Pluggable Ports pane, click Create. The Create Port dialog box appears.
Step 6
In the Create Port dialog box, complete the following:
•
Port—Click the PPM number and port number from the drop-down list. The first number indicates
the PPM and the second number indicates the port number on the PPM. For example, the first PPM
with one port displays as 1-1 and the second PPM with one port displays as 2-1. When a 4PIO is
present on an ASAP card, the port is identified as 4PIO#-PPM#-Port# (for example 4-4-1). The 4PIO
number can be 1 to 4, the PPM number can be 1 to 4, but the port number is always 1.
the PPM and the second number indicates the port number on the PPM. For example, the first PPM
with one port displays as 1-1 and the second PPM with one port displays as 2-1. When a 4PIO is
present on an ASAP card, the port is identified as 4PIO#-PPM#-Port# (for example 4-4-1). The 4PIO
number can be 1 to 4, the PPM number can be 1 to 4, but the port number is always 1.
•
Port Type—Click the type of port from the drop-down list. The port type menu displays the
supported port rates on your PPM. See
supported port rates on your PPM. See
for definitions of the supported rates on the ASAP
card.
Step 7
Click OK.
Step 8
Repeat Steps
through
to configure the port rates as needed.
Purpose
This procedure provisions the line rate on a multirate pluggable port
module (PPM). Single-rate small-form factor pluggables (SFPs) or 4-port
I/O modules (4PIOs) do not need line rate provisioning.
module (PPM). Single-rate small-form factor pluggables (SFPs) or 4-port
I/O modules (4PIOs) do not need line rate provisioning.
Tools/Equipment
None
Prerequisite Procedures
Required/As Needed
Required
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher
Table 11-1
PPM Port Types
Card
Port Type
ASAP
•
OC-3—155 Mbps
•
OC-12—622 Mbps
•
OC-48—2.48 Gbps
•
ETHER—10 Gbps Ethernet