Motorola PTP 600 Series ユーザーズマニュアル

 

 

144

9 Recovery 

Mode 

The Motorola PTP 600 point-to-point wireless Ethernet bridges have a special mode of 

operation that allows the user to recover a unit from configuration errors or software image 

corruption. 

Recovery mode is entered by depressing the Recovery Switch located on the underside of 

the PIDU Plus while applying mains power, as shown in section 3.3.2. The Recovery Switch 

should be held in the depressed state for between 10 and 20 seconds after the application of 

mains power. The Ethernet LED will flash with 10 double flashes at power up. 

When in recovery mode the user will be able to access the unit via the Ethernet interface. The 

Ethernet interface will have it’s IP address set to 169.254.1.1. On connection to a unit in 

recovery mode the following screen is displayed (Figure 80):