Motorola PTP 600 Series ユーザーズマニュアル

 

 

183

13.8 Installation 

The section covers the generic installation instructions for the Connectorized versions of the 

PTP 600 Series point-to-point wireless Ethernet bridges. The actual installation procedure will 

depend on antenna choice, cable choice, required antenna separation etc. 

13.8.1 Antenna 

Choice 

Table 21 shows a wide variety of antennas that can be used with the Connectorized 600 

Series bridge. The main selection criteria will be the required antenna gain. The secondary 

criteria should be the ease of mounting and alignment. For example the Radio Waves 

Parabolic dishes are supplied with a mount that allows adjustment for alignment independent 

of the actual antenna mounting. This type of antenna is much easier to align than those that 

have to be rotated around the mounting pole for alignment. 

13.8.2  Cables and Connectors 

Cables should be selected using the above criteria. However it should be noted that a cable 

of a type similar to LMR400 is a lot more difficult to handle and route than a cable of a type 

similar to LMR100. 

Motorola recommends the use of weatherproof connectors -- preferably, ones that come 

supplied with adhesive lined heat shrink sleeve that is fitted over the cable/connector 

interface. 

The connectors required at the Connectorized 600 Series bridge end of the antenna cables 

are N-Type Male. 

The connectors required at the antenna end of the antenna cables is dependant on the 

antenna type chosen. 

13.8.3 Tools 

The tools required for mounting a Connectorized 600 Series bridge unit are the same as 

those required for an Integrated 600 Series bridge detailed in section 7.3. The tools required 

for mounting the antennas are specific to the antenna chosen. The installer should refer to the 

antenna manufacturer’s instructions.