Netgear WAG102NA ユーザーズマニュアル

Advanced Configuration

4-5

To configure a point-to-point bridge as shown in 

:

1. Under Advanced on the main menu, select Advanced Access Point Settings 11a or Advanced 

Access Point Settings 11b/g. The Advanced Access Point Settings screen will display.

2. Configure the WAG102 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode.

3. Configure the WAG102 (AP2) on LAN Segment 2 in Point-to-Point Bridge mode. 

AP1 must have AP2’s MAC address in its Remote MAC Address field and AP2 must have 
AP1’s MAC address in its Remote MAC Address field.

4. Configure and verify the following parameters for both access points:

•

Verify that the LAN network configuration of the WAG102 Wireless Access Points both 
are configured to operate in the same LAN network address range as the LAN devices

•

Both use the same ESSID, Channel, authentication mode, if any, and security settings if 
security is in use.

5. Verify connectivity across the LAN 1 and LAN 2. 

A computer on either LAN segment should be able to connect to the Internet or share files and 
printers of any other PCs or servers connected to LAN Segment 1 or LAN Segment 2.

6. Click Apply to save your settings.

AP in
Point-to-Point
Bridge Mode

AP in
Point-to-Point
Bridge Mode

E T H E R N E T

R E S E T

5 - 1 2 V D C

E T H E R N E T

R E S E T

5 - 1 2 V D C