Netgear WAG102NA ユーザーズマニュアル

4-6

Advanced Configuration

To configure a point-to-multi-point wireless bridge as shown in 

:

1. Under Advanced on the maim menu, select Advanced Access Point Settings 11a or Advanced 

Access Point Settings 11b/g. The Advanced Access Point Settings screen will display.

2. Configure the Operating Mode of the WAG102 Wireless Access Points.

•

WAG102 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode with the Remote MAC 
Address of AP2.

•

Because it is in the central location, configure WAG102 (AP2) on LAN Segment 2 in 
Point-to-Multi-Point Bridge mode. The MAC addresses of the adjacent APs are required 
in AP2.

•

Configure the WAG102 (AP3) on LAN 3 in Point-to-Point Bridge mode with the Remote 
MAC Address of AP2.

3. Verify the following parameters for all access points:

•

Verify that the LAN network configuration the WAG102 Wireless Access Points are 
configured to operate in the same LAN network address range as the LAN devices

•

Only one access point is configured in Point-to-Multi-Point Bridge mode, and all the 
others are in Point-to-Point Bridge mode.

•

All access points must be on the same LAN. That is, all the APs LAN IP address must be 
in the same network.

'Master' AP in
Point-to-Multi-Point
Bridge Mode

AP in
Point-to-Point
Bridge Mode

AP in
Point-to-Point
Bridge Mode

E T H E R N E T

R E S E T

5 - 1 2 V D C

E T H E R N E T

R E S E T

5 - 1 2 V D C

E T H E R N E T

R E S E T

5 - 1 2 V D C