SMC Networks Barricade ユーザーズマニュアル

-10- 

 

To use the Barricade correctly, you must properly configure the network settings of your 

computers and install the attached setup program into your MS  Windows platform 

(Windows 95/98/NT). 

The default IP address of the Barricade is 192.168.123.254, and the default subnet mask is 

255.255.255.0. These addresses can be changed to fit your needs, but the default values are 

used in this manual. If the TCP/IP environment of your computer has not yet been 

configured, you can refer to Appendix B to configure it. For example, 

1.  configure  IP as 192.168.123.1,  subnet mask as 255.255.255.0 and  gateway as 

192.168.123.254 

2.  configure your computer to load the TCP/IP setting automatically, i.e., via DHCP 

server. 

After installing the TCP/IP communication protocol, you can use the ping command to 

check if your computer has successfully connected to this product. The following example 

shows the ping procedure for Windows 95 platforms. First, execute the ping command 

ping 192.168.123.254 

If the following messages appear:  

Reply from 192.168.123.254: bytes=32 time=2ms TTL=64 

a communication link between your computer and this product has been successfully 

established.  

If you get the following message: