ZyXEL Communications P-660HN-F1 ユーザーズマニュアル
Chapter 21 Tools
P-660HN-F1 User’s Guide
293
4 Use the TFTP client (see the example below) to transfer files between the device and the
computer. The file name for the firmware is “ras”.
Note that the telnet connection must be active and the device in CI mode before and during the
TFTP transfer. For details on TFTP commands (see following example), please consult the
documentation of your TFTP client program. For UNIX, use “get” to transfer from the device
to the computer, “put” the other way around, and “binary” to set binary transfer mode.
TFTP transfer. For details on TFTP commands (see following example), please consult the
documentation of your TFTP client program. For UNIX, use “get” to transfer from the device
to the computer, “put” the other way around, and “binary” to set binary transfer mode.
TFTP Upload Command Example
The following is an example TFTP command:
tftp [-i] host put firmware.bin ras
Where “i” specifies binary image transfer mode (use this mode when transferring binary files),
“host” is the device’s IP address, “put” transfers the file source on the computer (firmware.bin
– name of the firmware on the computer) to the file destination on the remote host (ras - name
of the firmware on the device).
“host” is the device’s IP address, “put” transfers the file source on the computer (firmware.bin
– name of the firmware on the computer) to the file destination on the remote host (ras - name
of the firmware on the device).
Commands that you may see in GUI-based TFTP clients are listed earlier in this chapter.
Using the FTP Commands to Back Up Configuration
1 Launch the FTP client on your computer.
2 Enter “
2 Enter “
open
”, followed by a space and the IP address of your ZyXEL Device.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is “1234”).
5 Enter “
4 Enter your password as requested (the default is “1234”).
5 Enter “
bin
” to set transfer mode to binary.
6 Use “
get
” to transfer files from the ZyXEL Device to the computer, for example, “
get
rom-0 config.rom
” transfers the configuration file on the ZyXEL Device to your
computer and renames it “
config.rom
”. See earlier in this chapter for more
information on filename conventions.
7 Enter “
quit
” to exit the ftp prompt.
FTP Command Configuration Backup Example
This figure gives an example of using FTP commands from the DOS command prompt to save
your device’s configuration onto your computer.
your device’s configuration onto your computer.
Figure 174 FTP Session Example
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit