ZyXEL Communications P-660HN-F1 ユーザーズマニュアル

Chapter 21 Tools

P-660HN-F1 User’s Guide

The following table describes some of the commands that you may see in GUI-based FTP 
clients.

The ZyXEL Device supports the up/downloading of the firmware and the configuration file 
using TFTP (Trivial File Transfer Protocol) over LAN. Although TFTP should work over 
WAN as well, it is not recommended.

To use TFTP, your computer must have both telnet and TFTP clients. To backup the 
configuration file, follow the procedure shown next.

1 Use telnet from your computer to connect to the ZyXEL Device and log in. Because 

TFTP does not have any security checks, the ZyXEL Device records the IP address of 
the telnet client and accepts TFTP requests only from this address.

2 Enter command “

sys stdio 0

” to disable the management idle timeout, so the TFTP 

transfer will not be interrupted. Enter command “

sys stdio 5”

 to restore the five-

minute management idle timeout (default) when the file transfer is complete.

3 Launch the TFTP client on your computer and connect to the ZyXEL Device. Set the 

transfer mode to binary before starting data transfer.

4 Use the TFTP client (see the example below) to transfer files between the ZyXEL 

Device and the computer. The file name for the configuration file is “

rom-0

” (rom-zero, 

not capital o).

Note that the telnet connection must be active before and during the TFTP transfer. For details 
on TFTP commands (see following example), please consult the documentation of your TFTP 
client program. For UNIX, use “

get

” to transfer from the ZyXEL Device to the computer and 

“binary” to set binary transfer mode.

The following is an example TFTP command:

tftp [-i] host get rom-0 config.rom

where “

i

” specifies binary image transfer mode (use this mode when transferring binary files), 

“

host

” is the ZyXEL Device IP address, “

get

” transfers the file source on the ZyXEL Device 

(

rom-0

, name of the configuration file on the ZyXEL Device) to the file destination on the 

computer and renames it config.rom.

Table 120   General Commands for GUI-based FTP Clients

Host Address

Enter the address of the host server.

Login Type

Anonymous.
This is when a user I.D. and password is automatically supplied to the 
server for anonymous access.  Anonymous logins will work only if your 
ISP or service administrator has enabled this option.
Normal.  
The server requires a unique User ID and Password to login.

Transfer Type

Transfer files in either ASCII (plain text format) or in binary mode.

Initial Remote Directory

Specify the default remote directory (path).

Initial Local Directory

Specify the default local directory (path).