ZyXEL Communications 1001H ユーザーズマニュアル
P100IH ISDN Router
2-2
Hardware Installation and Setup
2.2 Prestige 100IH Rear Panel and Connections
The figure below shows the rear panel of your Prestige 100IH and the connection diagram.
Figure 2-2 Prestige 100IH Rear Panel and Connections
Step 1.
Connecting a Telephone/Fax to the Prestige
You can connect regular telephones, fax machines or other analog devices to the Prestige. To connect an
analog device, plug the end of the telephone cord from the device to either port PHONE1 or PHONE2 on
the rear panel of the Prestige.
analog device, plug the end of the telephone cord from the device to either port PHONE1 or PHONE2 on
the rear panel of the Prestige.
Step 2.
Connecting the ISDN Line
Connect the Prestige to the ISDN network using the included ISDN (black) cable. Plug one end of the
cable into the port labeled ISDN BRI and the other to the ISDN wall jack.
cable into the port labeled ISDN BRI and the other to the ISDN wall jack.
Step 2.
Connecting the Console Port
For the initial configuration of your Prestige, you need to use terminal emulator software on a workstation
and connect it to the Prestige through the console port. Connect the 9-pin (smaller) end of the console cable
to the console port of the Prestige and the 25-pin (bigger) end to a serial port (COM1, COM2 or other COM
port) of your workstation. You can use an extension RS-232 cable if the enclosed one is too short.
and connect it to the Prestige through the console port. Connect the 9-pin (smaller) end of the console cable
to the console port of the Prestige and the 25-pin (bigger) end to a serial port (COM1, COM2 or other COM
port) of your workstation. You can use an extension RS-232 cable if the enclosed one is too short.
After the initial setup, you can modify the configuration remotely through telnet connections. See the Telnet
Chapter for detailed instructions on using telnet to configure your Prestige.
Chapter for detailed instructions on using telnet to configure your Prestige.