ZyXEL Communications 1001H ユーザーズマニュアル
P100IH ISDN Router
Hardware Installation and Setup
2-3
Step 4.
Connecting a Workstation to the Prestige
Ethernet 10Base-T networks use Unshielded Twisted Pair (UTP) cable with RJ-45 connectors that look like
a bigger telephone plug with 8 pins. Connect a workstation to the built-in hub on the Prestige 100IH to
create an Ethernet network. Connect one end of a straight through Ethernet cable (white tag) to the NIC on
the workstation and the other end to one of the built-in 4 Ethernet ports on the Prestige 100IH (Figure 2-2).
a bigger telephone plug with 8 pins. Connect a workstation to the built-in hub on the Prestige 100IH to
create an Ethernet network. Connect one end of a straight through Ethernet cable (white tag) to the NIC on
the workstation and the other end to one of the built-in 4 Ethernet ports on the Prestige 100IH (Figure 2-2).
Step 5.
Connecting the Power Adapter to your Prestige
Connect the power adapter to the port labeled POWER on the rear panel of your Prestige.
2.3 Additional
Installation
Requirements
In addition to the contents of your package, there are other hardware and software requirements you need
before you can install and use your Prestige. These requirements include:
before you can install and use your Prestige. These requirements include:
1. A computer with Ethernet 10Base-T NIC (Network Interface Card).
2. A computer equipped with communications software configured to the following parameters:
♦ VT100 terminal emulation.
♦ 9600 bps (bits per second).
♦ No parity, 8 Data bits, 1 Stop bit.
After the Prestige is properly set up, you can make future changes to the configuration through telnet
connections.
♦ 9600 bps (bits per second).
♦ No parity, 8 Data bits, 1 Stop bit.
After the Prestige is properly set up, you can make future changes to the configuration through telnet
connections.