Alcatel Carrier Internetworking Solutions Switch/Router ユーザーズマニュアル

Page 28-39

This column indicates the physical cable type connected to this port. This cable type is 
automatically sensed by the 

WSX

 hardware. This column indicates the cable type and whether 

it is 

DCE

 or 

DTE

. The following values may appear in this column:

•

 (V.35 DTE cable)

•

 (V.35 DCE cable)

•

 (RS-232 DTE cable)

•

 (RS-232 DCE cable)

•

 (X.21 DTE cable)

•

 (X.21 DCE cable)

•

 (RS-530 or RS-449 EIA DTE cable)

•

 (RS-530 or RS-449 EIA DCE cable)

•

 

•

 

The 

WSX

 sees 

RS-530

 and 

RS-449

 cables the same because they are electrically identical. 

However, this does not affect the operation of either cable type. Both 

RS-530

 and 

RS-449

 

cables are supported.

If no cable is connected to a universal serial port, then this column will display:

If an error has been detected on the port (e.g., cable type could not be detected), the 
following value displays:

This column shows the Administrative and Operational State of this 

WSX

 port. The value 

before the slash refers to the Admin Status. If 

, the port has been enabled and can transmit 

data as long as its Operational State is also 

. If the Admin Status is 

, the port will not 

pass data even if its physical connection is good.

The value after the slash refers to the Operational State. If 

, the port is capable of passing 

data as long as it has been logically enabled at the Administrative level. If 

, the port cannot 

pass data due to a problem in the physical connection (e.g., cable disconnected, 

WSX 

could 

not detect cable type) or because the port is administratively down. If the Operational State 
displays 

, the port is currently in Loopback (test) mode.

The protocol type can be set to either Frame Relay or Point to Point Protocol (PPP).